include
Specifies the MAC addresses included
in the NAC enforcement list
Supported on the following devices:
- Access Points:
AP3000/X, AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP7602, AP7612, AP7622, AP7632,
AP7662, AP8163, AP8533.
- Service Platforms:
NX5500, NX7500, NX9500, NX9600
- Virtual Platforms: CX9000, VX9000
Syntax
include <START-MAC> [<END-MAC> precedence <1-1000>|precedence <1-1000>]
Parameters
include <START-MAC> [<END-MAC> precedence <1-1000>|precedence <1-1000>]
| <START-MAC> |
Specifies a range of MAC addresses or a single MAC address to include in
the NAC enforcement list
- <START-MAC> –
Specify the first MAC address in the range.
Note: Use this parameter
to specify a single MAC address.
|
| <END-MAC> |
Specifies the last MAC address in the range (optional if a single MAC is
added to the list)
- <END-MAC> –
Specify the last MAC address in the range.
|
| precedence <1-1000> |
Sets the rule precedence. Include entries are checked in the order of
their rule precedence.
- <1-1000> –
Specify a value from 1 - 1000.
|
Examples
nx9500-6C8809(config-nac-list-test)#include 00-15-70-38-06-49 precedence 2
nx9500-6C8809(config-nac-list-test)#show context
nac-list test
exclude 00-04-96-B0-BA-2A 00-04-96-B0-BA-2A precedence 1
include 00-15-70-38-06-49 00-15-70-38-06-49 precedence 2
nx9500-6C8809(config-nac-list-test)#
